Roomba® Max 700 Series: How to Clean or Replace the Mop Pad

Cleaning the PowerSpin™ Roller Mop with PerfectEdge®

1. Slide the green release button over to the edge clip of the PowerSpin™ Roller Mop. This will release the edge clip from the PowerSpin™ Roller Mop Scraper.
   
   
   
   

2. Hold the edge clip and pull out the PowerSpin™ Roller Mop.
   
   
   

3. Press Release Button on the PowerSpin™ Roller Mop Scraper Assembly and slide the scraper out.
   
   

4. Clear all hair and debris from behind and between the edge clip and roller mop scraper.
   
   
   

5. Gently peel back the rubber strip by lifting from the corner marked with an arrow, leaving the opposite end attached.
   
   
   

6. Rinse and wipe clean any residue on and from beneath the rubber strip.
   
   
   
   

7. Reinsert the rubber strip starting from the same side you pulled to remove the strip marked with an arrow.
   
   
   

8. Press down the rubber strip starting from the opposite side of the inserted side until it lies completely flat all the way across.
   
   
   

9. With the roller mop cover in the retracted position, clean the actuator so it's free of debris and build-up.
   
   
   
   

IMPORTANT: If the roller mop cover is closed, do not try to force it open.

10. Reinstall the PowerSpin™ Roller Mop Scraper.
    
    
    

11. Reinstall PowerSpin™ Roller Mop.
    
    
    

12. PowerSpin™ Roller Mop Scraper is properly installed in place when you hear a 'click', and the robot will say, "The rolling mop pad has been installed."
    
    

If you do not hear this noise, the mop roller is not fully seated/latched. Try holding the green button down as you slide/secure the mop pad in place.